I’m only half kidding. I’m a bit of a prepper and I have lots of powerbanks and devices that charge from USB but besides idling my truck I really had no other way to charge any of them in case of a long-term power outage which seemed a bit of an oversight on my part.

Not like this solves the issue. 30 watts (under ideal conditions) isn’t much but it’s a start.

  • Marafon@sh.itjust.works
    7·
    1 day ago

    Thank you for the primer! I find it very interesting and you’ve certainly given me plenty of things to research and learn more about.

    I think my biggest goal is actually power stability but the cheaper power bill would be a welcome bonus. In my new shop the table saw seems to trip it’s little built in circuit breaker a lot more often when it is cutting thick hardwood than it did in my old shop. Unless the blade is sharp as shit resawing on the table saw is a distant memory lol.

    I think it’s because the run from the road to the house main is a long run and then from the house main 60 amps is routed out to the shop which is another long run out to the shops breaker box. Then from there I use a 25 ft 12 awg extension cord to power the saw and dust collector via an automatic vacuum switch. The saw very rarely tripped at the old house when the total run from the road to the saw was less than 50 feet and I never did it any favors. But now that it is hundreds of feet away from the source I think the voltage drops off and it over heats and trips the sawstops little breaker.

    I hope that made sense, I’m a carpenter not an electrician lol. What I think I need is a battery set up for the shop that acts like a giant Uninterruptible Power Supply to combat the “dirty” power and put the saw closer to the source. The ability to power a hybrid solar/dehumidifier kiln in the future from the shop without sacrificing power reliability would also be something I would want to consider.

    Thank you again for the write up on your setup!